Guide to the Battery in the Immersive EEG System
A guide to changing and charging the battery in the Immersive EEG system.
Changing the Battery
Verify that the Immersive system is turned off via the power switch on the underside of the battery compartment. Open the battery cover and remove the battery. Insert a charged battery with the negative pole (flat end) against the spring.
Charging the Battery
The battery has a microUSB port on it. This can be connected directly to a 5V power supply via the included cable. The LED light on the battery will turn blue when fully charged.
Use a power supply that conforms to the UNE-EN60950-1:2007 standard, or damage to the battery could result. To preserve battery life, remove the battery once fully charged.
If the Immersive system is being stored for a long period of time, remove the battery. If storing the battery for more than a week or two, discharge the battery somewhat (i.e. do not store at 100% charge) or this could permanently reduce the charge capacity.
Note: Do not charge the battery while in use.
Battery Duration and Recharge
The battery should last for more than 3 hours of continuous operation in the Immersive system. The recharge time should take less than 3 hours.
If the battery duration is substantially reduced, it may be time to replace it. Contact Bitbrain support for more information.
The battery used by the Immersive system is the Fenix ARB-L16-700U USB Li-ion 16340.
Working temperature range:
0ºC to 45ºC (32ºF to 113ºF)
Storage temperature range:
-20ºC to 60ºC (-4ºF to 140ºF) for up to 1 month
-20ºC to 30ºC (-4ºF to 86ºF) for up to 6 months
Note: Batteries don't last forever! Over time the capacity and performance will be reduced. Replace only with this exact approved model. The use of another kind of battery could cause malfunction, including the risk of fire and explosion.